Thanks:
0
Likes:
0
Dislikes:
0
-
010-320 error code - xerox docucolor 242 - NVM Reset Help Needed
I have gone throughthe steps to reset the nvms to 0 with no luck.
I set the chain to 744 and the function to 156 but there was no "read" button. Now what?
Thanks
micah@xstellar.com
877-624-5237
-
Re: 010-320 error code - xerox docucolor 242 - NVM Reset Help Needed
Um... have you tried first replacing the fusing unit?
10-320 is an overhead error.
Also, before replacing the fusing unit, check to make sure you don't have a bit of paper stuck in the fuser connector (fuser side or frame side)
If paper was found and or new fuser installed, then reset NVM 744-350 to 0.
If its not paper stuck in the connector, or the fusing unit. Check wiring for a short or open.
If still nothing found, replace Power unit (PL 11.3) and or MCU (PL 11.1) in that order.
-
Re: 010-320 error code - xerox docucolor 242 - NVM Reset Help Needed
You meant overHEAT error ya?
and yes I replaced with bran new fuser.
No paper anywhere. There is a step that it wont allow me to do is my issue,
after i enter into the adjustments menu there is no READ button to press.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks