Xerox 5687 - PWS Altboot - Linux files and Scanenablement codes needed

[Majestik355]

I have a 03-544 NC not available code. PWS altboot option (1) shows correct booting of NC software, but it does not communicate with SIP (fireware reports ok in altboot diagnostics), cause machine shows NC is booting up even if NC is not powered on. I have tried removing the firewire card and forced system software upg, no use. Should I perform an altboot from the PWS and replace all software? If yes, I need the Linux Kernel and Linux Root files, cause I don´t have the system software CD. Also enablement codes for Scanning (network & email) are needed. Thanks for your help.

[adriansto]

First you must say what software version is on to machine.
Second - how do you know the NC boot is correct ?
All four ( 4 ) mesages at the end of booting process appear in altboot window ?

[Majestik355]

First you must say what software version is on to machine.
Second - how do you know the NC boot is correct ?
All for mesages at the end of booting process appear in altboot window ?

For system it is 20.120.52.000, I don't know for the NC software. From Altboot with option 1, I see NC is normally booted and arrives to the login line: Xerox5687 login: and the line pasword: after it. I dont know the user and pasword, if I needed to do something more. I'm not sure what 4 messages must be. Thanks.

[adriansto]

Anastas I sent you email.
After the lines with user and passwd the boot process must go on. You dont need to type anything.

[Majestik355]

Anastas I sent you email.
After the lines with user and passwd the boot process must go on. You dont need to type anything.

Ok, I'll wait for it. Thanks for the e-card, Season's greetings for 2014 and best wishes to you too.

[Majestik355]

Ok, I'll wait for it. Thanks for the e-card, Season's greetings for 2014 and best wishes to you too.

Case solved. Reloaded software via Altboot and there was no need for any scan enablement codes. It reloaded the codes itself during/after software reload and Network controller is now available, connected to machine. Thanks.