Hello All,
I'm looking for Docucolor 240/250 bustled Fiery Software. I currently have the CD but need the Software version for USB Flash installation.
Thanks in advance
Hello All,
I'm looking for Docucolor 240/250 bustled Fiery Software. I currently have the CD but need the Software version for USB Flash installation.
Thanks in advance
Why you need this-USB_Flash_Drive_Preparation_v3.21- if you have Software cd ?
Last edited by adriansto; 01-28-2014 at 08:54 PM.
are you looking for the usb flash drive making software? This software basically loads the system software on the usb flash... -OR- are you looking for the USB flash drive software?
I need the actual software. I have the USB prep and the Flash tools.
USB prep wont work on a 240/250 so I need to use the Flash.
The Fiery on occasion wont take the SW using the CD via a crossover cable. I need an alternate method. I have read that loading via a flash drive is the best way.
But you cant load the CD onto the Flash drive because it's a Image file. You would need the SW.
Thanks again for your help.
I have software...
Only 1 CD its v1.0. I have tried to load onto the USB using USB_Flash_Drive_Preparation_v3.21 but it fails.
When I try to install with CD via crossover it gives me an "Installation Failed" after step 2 has started. I have two controllers that stop at the same spot when attempting to install??
Send mail at stoadis@gmail.com
I have the same problem. I need an installation CD SW 1.2 version with instructions if someone can send. thanks in advance
In fact there are three cd's for this software version or a 2GB USB stick with preloaded software.
Bookmarks