Xerox dc12 Error

[Enzo]

Did the problems start after you replaced the fuse?

yes friend. just a few days later. and I have changed the entire 2BTR and clutches are new.

[mickey singh]

Can you get a pic up and rating/ amp of fuse you changed, I have a box of dc 12 bits and tons of fuses knocking bout!

[Enzo]

hello friends. I have a problem with the dc12. the copy faded out completely. I changed IBT, I changed 2btr, I changed the drum, I started the MAX setup. nothing to do! What can it be?

[Enzo]

the copy comes out as type "watermark", and very white. then, all of a sudden the copy comes out nice, is not optimal. What can it be?
I am told that it is a problem of cards, but which card?
I changed the "2nd BTR HVPS," but the problem remains.
tell me to change the "IOT CPU PWB" and "Half tone PWB."
In addition, the machine shows me this error: 3-327. this error does not show the display of the machine, but the diagnostic software.
I think that the bad copy out because of an incorrect connection between some cards.
because drum, 2BTR, IBT and fuser are new!
I ask help to you my friends!

[mickey singh]

Put up pics, or email me mickeysinghbhamra@outlook.com!

[Enzo]

unfortunately I can not do a scan of the error of the machine because the copy gets out almost white. this is an example:

pic original.jpgpic copy error.jpg

I repeat, until a few days ago was working perfectly!
last month I changed:
- DEVELOPER
- 2nd BTR
- IBT
- FUSERS
- DRUM
- (105K14914) 2nd BTR HVPS

however, at times, the copy comes out fine, but it is noted that it is still too light.