Battery on MCU NVM PWB died. Replaced. Now I need to sync the serials. I can generate a unique machine identifier, but still need a password (dc132). I called Xerox support and they did not have a way of getting the password.

Please help.

REP 1.27 MCU NVM PWB
Parts List on PL 13.1
Removal
1. Gather all available settings information.
• Machine NVM log if available
• MRD if available
• Copy of Configuration Report if available/applicable.
CAUTION
PWB’s can be damaged by electrostatic discharge. Observe all ESD procedures.
2. Pivot HVPS down (REP 1.6).
CAUTION
The MCU NVM PWB has a lithium battery. Dispose of the used battery following the manufac-
turers' instructions after replacing. Do not throw it away at customer's site.
3. Remove MCU NVM PWB (PL 13.1).
a. Release MCU NVM PWB mounting post and slide MCU NVM PWB off of post.
b. Disconnect MCU NVM PWB from MCU PWB.
Replacement
1. Install MCU NVM PWB on MCU PWB.
a. Install MCU NVM PWB on MCU PWB and engage post.
b. Reposition HVPS (REP 1.10).
2. Call Service Support to re serialize machine (dC132).
3. Switch on the power.
4. Enter the Diagnostic Mode. Refer to Entering Diagnostic Navigator.
5. If MRD is available, go to steps 6 and 7.
If MRD is not available, go to steps 8 through 15.
6. Select DC361 in DC Quick widow to restore NVM.
a. Select Restore.
b. Insert MRD into A drive on PWS.
c. Navigate to appropriate file.
d. Select appropriate file name that was saved in step 5 of removal.
e. Select OK.
7. Switch the machine power off then on. Verify machine operation. Procedure is complete.
8. On networked machines, ensure that the network information (IP address, etc.) is correct.
Contact the customer’s system administrator to configure, if necessary. Replacement is
complete.
9. Perform Init (DC301) dC301.
10. Perform S/N Synch (DC132) dC132.
11. Perform Sys Reg (DC129) dC129.
12. Perform Size Detection (DC527) dC527 on DADF machines.
13. Perform Regi-Con (DC685) dC685.
14. Perform MAX Setup (DC929) dC929.
15. Switch the machine power off then on. Verify machine operation. Procedure is complete.