found a blown fuse of 30mA, on the fuser, i replaced but keeps blowing , any help ?
thanks
found a blown fuse of 30mA, on the fuser, i replaced but keeps blowing , any help ?
thanks
send all fault code plz!!!
here....
check the pictures
20170207_165746.jpg
20170207_164930.jpg
20170207_164913.jpg
20170207_165827.jpg
20170207_165842.jpg
hi check.....>
[IMG]pws://file/xerox/edoc/wc7556f/icons/wordproc.gif[/IMG] 310-381 Fuser Assy Illegal Fault
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]BSD On
BSD 10.4 Fusing Heat Control (2 of 2)
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]Description
A different type of Fuser Assembly (rapid heating/accumulative heating) was installed.
NOTE:
When turning the power OFF, turn OFF the Power Switch first and then the Main Power Switch.
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG] Cause/Action
- Turn the power OFF and ON.
- Turn the power OFF and replace with the correct Fuser Assembly ( PL 7.1).
and Check...>
310-382 Fuser Thermostat Fault
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]BSD On
BSD 10.4 Fusing Heat Control (2 of 2)
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]Description
The Fuser Assembly Thermostat is broken.
NOTE:
When turning the power OFF, turn OFF the Power Switch first and then the Main Power Switch.
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]Initial Action
- Turn the power OFF and remove the Fuser Assembly. The Drawer Connector between the Fuser Assembly and the Main Unit ( P/DJ600) for broken/bent pins, foreign substances, burns, and etc.
- Check whether the MCU PWB connector J431 is connected properly.
[IMG]pws://file/xerox/edoc/wc7556f/icons/arrwup.gif[/IMG]Procedure
Measure the resistance between P600 pin-A11 and P600 pin-B9.
Is the resistance infinite? Yes No Unanswered
Check the following connections for open circuits, short circuits, and poor contacts.
If no problems are found, replace the MCU PWB.
Replace the Fuser Assembly ( PL 7.1).
good lucky
Hi Techs, I have the same error on a Xerox WorkCentre 7835i, the machine in the middle of printing and displayed the fuser system error accompanied by errors below 310.382.200, 377.901.00, 310.330.00, 310.370.00
Help me to resolve this.
Thankyou.
Herbert Nyirongo.
I replaced the fuser assembly with a new one and changed the NVM 744 001 to 0 the fuser error still appears
310.372.00 still appears on the fault history.
Help..
Herbert Nyirongo
Check again if 744-001 nvm is set to zero
Check the connector from machine in which the fuser connector enter - pj6000
Check connector pj 431 from MCU pwb.
Bookmarks