Hi everyone,
I have a Xerox DC 252 that just started printing all colours off register, especially cyan and magenta are off by 0.5 mm. Any idea how to fix this.
Your help is much appreciatd.
Hi everyone,
I have a Xerox DC 252 that just started printing all colours off register, especially cyan and magenta are off by 0.5 mm. Any idea how to fix this.
Your help is much appreciatd.
Could be any number of things, start by doing the following. Then do Test pattern 1 in full color to test the registration
Under Registration:
Registration Measuring Cycle
Registration Control Sensor Check Cycle
Registration Control-Setup Cycle
Good Luck
I noticed that the problem seems to be with black only, itīs off register by 1 mm. All other colors line up in register. I changed a new black drum but still the same.
Enter Diagnostics and select System settings / Common settings / Maintenance & Diagnostics / Subsystem / Belt Edge Learn / START button, (wait for: Routine complete) / Close / Registration / Registration Measurement Cycle / Start (wait for: Routine complete) / Registration Control Setup / START button, (wait for the routine to complete) / Close / Exit.
Print from machine service menu one A4 sheet with magenta 40%, A4 with cyan same coverage, A4 yellow and A4 black. Check how these papers looks. Post here.
Hello ,
Just in case check for black drum drive motor , the ones with the long shaft , color ones are interchangeable but only one black , also check for the motor PWBA and last resort save your NVM data first the resets all NVM's just to clear any data corruption , -------- remember save your machine NVM'S first ---------------------- .
hope this help,
Wiwa 72 , Gonzos build V. 1.0
Registration Problem is fixed, turn out to be a faulty MOB. Now I have another problem: the machine is dispensing a lot of cyan Toner at start up.
the belt is full of solid cyan. which in turns give error 042-326.
I cleaned the belt, got the machine to run. I can hear some noise, as if some motor is failing. it lasts about 10 sec., then the machine prints colors but no cyan.
What's going on with the cyan?
Last edited by mpsolutions; 04-13-2015 at 04:29 PM.
Bookmarks