Thanks:
0
Likes:
0
Dislikes:
0
-
Energy saver button blinking only
Swapped out power supply and still get energy saver button blinking only. Black screen. Nothing else happens.
any thoughts?
-
Re: Energy saver button blinking only
You didn't mention make and model, but I have seen the hard drive cause this on Samsung machine
-
Re: Energy saver button blinking only workcentre 5638
-
Re: Energy saver button blinking only
-
Senior Tech
250+ Posts
- Rep Power
- 33
Re: Energy saver button blinking only
pls chk dc power supply for 5vdc or 3.3vdc output ?if normal then remove hdd and reboot machine ,mc recover?if same problem pls chg ess board and after recover pls set energy saver to off .
-
Re: Energy saver button blinking only
How to turn energy saver completely off?
-
Senior Tech
250+ Posts
- Rep Power
- 33
Re: Energy saver button blinking only
at the moment i still searcing my old archieve for this model SM ..for countermeasure u can set low and sleep mode to max time.
-
Re: Energy saver button blinking only
NVM 616-002 is used to fully disable energy saver. It's cheaper than replacing the LVPS
Sent from my iPhone using Tapatalk
-
Re: Energy saver button blinking only
If you can't get the machine to boot up you won't be able to change an NVM setting. It sounds like a LVPS problem but it could also be an electrical short someplace in the machine. If you suspect its a short try to disconnect all units one at a time till you find the one causing the problem.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks