First off I ALREADY KNOW HOW TO RUN THE NORMAL CALIBRATION IN SERVICE MODE!
Ok, that out of the way. I replaced the CPU board for the panel. It now works correctly but is about an inch off calibration which won't let me select things to get to the calibration area in service. I remember using an alternate recovery method which was found in e-support, but with Canon having issues I can't get to the knowledge base article.
Does anyone remember the alternate way to get to the calibration screen? Thanks.
Ok, that out of the way. I replaced the CPU board for the panel. It now works correctly but is about an inch off calibration which won't let me select things to get to the calibration area in service. I remember using an alternate recovery method which was found in e-support, but with Canon having issues I can't get to the knowledge base article.
Does anyone remember the alternate way to get to the calibration screen? Thanks.
Comment