If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have installed UFR II and PCL drivers on XP PC and all looks OK. Canon is found by driver install program, I can ping it and Remote UI comes up as normal. But test copy will not print. Spools on the PC and never prints.
So have tried all of following:
1. Installed driver on laptop and connected via crossover cable- Same result
2. Connected laptop via USB- same result ( Can see data light flash on Canon, "printing" comes up on control panel but nothing outputs. Log has NG #853.)
3. Checked HDD, formatted HDD, reseated memory on print PCB, reseated all connectors
