IR3245i fixing problem

[teckat]

customer-service2.jpg

[evinyar]

fusing issue

I would dought the toner if a bad toner get in there it would be a complete issue and usually it is not a fusing issue, more dusting or poor CQ in general. Unless there was a build up of carrire adjents on the DR blade not allowing toner to flow to these areas, this may explain the raised feel of the print.

[bobthecopierman]

Ran all day Friday and Monday without any issues. Noticed there were 0 jams. Latch bracket was bent inwards a little so i reformed it. Will keep an eye on it and post if the condition continues.
Thanks for the tips.

[mrfixit51]

You are welcome!

[charm5496]

good luck with this one!

[nick55]

Re: IR3245i fixing problem

what causes the annoying 0107 by the way. had any body have a permanent fixed for this?

Funny, had that exact thing on Friday.

3245, door being shoved with enough force to knock out David Hay.

And yes they were annoyed with the 0107 jamming season.

[teckat]

Re: IR3245i fixing problem

what causes the annoying 0107 by the way. had any body have a permanent fixed for this?

Canon Engineering

replace registration sensor PS9 (WG8-5783-000)

u have probably see all the other crappy suggestions from Canon on the imageRUNNER 2270 / 2870 / 3570 / 4570 pubs.

New Style Lower right Door Sheet
Replacement of the Vertical Path Guide
Replace SL1
Replace the Delivery Controller PCB
Replace the 2nd Delivery Hinge
Adjust the Cassettes so that the paper passes over ribs on both ends of the flapper.
Update DCON
Fixing Temperature Control Changes (Plain/Thick)raise for thick paper by 15 degrees-for plain paper (Lower by 20 degrees)

50554_58874548769_5767215_n.jpg

[nick55]

Re: IR3245i fixing problem

guess ur right... i think canon need to add one more vertical roller to hold or help push letter size paper when its on fuser assembly.