IR105 progress bar to the end

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jvargas
    Technician
    • May 2009
    • 44

    #1

    IR105 progress bar to the end

    I have a customer with IR8500, and the progress bar goes to the end, a nothing happens. i know that the problem is in the main controller, somebody know how to fixed it, thanks
  • teckat
    Field Supervisor

    Site Contributor
    10,000+ Posts
    • Jan 2010
    • 16083

    #2
    Originally posted by jvargas
    I have a customer with IR8500, and the progress bar goes to the end, a nothing happens. i know that the problem is in the main controller, somebody know how to fixed it, thanks


    First>>Remove memory and boot-rom / clean ends & re-seat or replace memory

    Try and Re-load Firmware

    **Knowledge is time consuming, exhausting and costly for a trained Tech.**

    Comment

    • jvargas
      Technician
      • May 2009
      • 44

      #3
      I did that, I change all, boot. dimm, cables, etc, exactly the problem is the controller, I hear that on chip in the target cause false contact, but which one, this is my question. Maybe someone had had this problem, thanks

      Comment

      • teckat
        Field Supervisor

        Site Contributor
        10,000+ Posts
        • Jan 2010
        • 16083

        #4
        u are going to try and repair the Main Controller ????

        trying to trace down a poor solder chip connection without diagnostic tools on a Main pcb. is not worth time and effort
        **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • jvargas
          Technician
          • May 2009
          • 44

          #5
          yes, i will fix the controller, but it to hard, thanks, i tell you if i can do that, later

          Comment

          Working...