iR C3100

[cyberfix]

Yellow not aligning correctly, all other colours appear to be ok, samples attached.

Attended to find "replace yellow" message with new Yellow Cartridge installed. Vacuumed internals including Yellow Dev Unit and Yellow Cartridge and reinstalled, cartridge accepted but misaligned as per attached PDF.

[teckat]

Re: iR C3100

Check the Rear Tension Arm on Trans Belt Assmy.
if it is the old type, replace it with a new type. "02" is
marked in the new type of tension arm (front) and tension arm (rear) to identify a new type tension arm.
ARM.JPGARM2.JPG
REPLACE BOTH
FRONT AND REAR ARM

New ARM, TENSION, FRONT FC5-0343-020
New ARM, TENSION, REAR FC5-0344-020
New INTER. TRANSFER BELT ASSEMBLY FM2-0081-090/ THIS UNIT HAS UPDATES/DOES NOT INC. BELT

[cyberfix]

Re: iR C3100

Thanks Techat, replaced the above mentioned parts but still a yellow alignment issue. Any other suggestion?

[londonboy]

Re: iR C3100

If you have replaced the arms, you still have an issue with the belt slipping, clean all the rollers and the inside of the belt, all else fails replace the ITB assy.

[Tricky]

Re: iR C3100

FC5-0337-030 ROLLER, INSIDE

This roller is inside the transfer belt assembly and nearest the main transfer roller.

The ends of this roller do wear down where they fit on the bearings.

Edit re read post did you change the entire transfer belt with a new one ?

[cyberfix]

Re: iR C3100

many thanks guys, replaced both Tension Arms and Inside Roller to solve the issue.

[teckat]

Re: iR C3100

many thanks guys, replaced both Tension Arms and Inside Roller to solve the issue.

Kudos_Logo.jpg