Feeding Fixing Unit Position

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • V-P
    Senior Tech

    Site Contributor
    500+ Posts
    • Apr 2011
    • 679
    #1

    Feeding Fixing Unit Position

    I have a case clc5151 where the left side Fixing feeding unit cover does not completely close up like the right side.

    Is there some registration to be done ?

    clc5151.pdf
    Attached Files
    Tags: clc, clc5151, cover, feeding, fixing, left, ratio, registration, side, unit
    • charm5496
      Service Manager

      Site Contributor
      1,000+ Posts
      • Apr 2008
      • 2387
      #2
      Re: Feeding Fixing Unit Position

      your latches are bent or broken for the drawer
      Accidents don't just happen. They must be carelessly planned.

        Comment

        • teckat
          Field Supervisor

          Site Contributor
          10,000+ Posts
          • Jan 2010
          • 16083
          #3
          Re: Feeding Fixing Unit Position

          Right on/the money

          seen this a hundred times/ usually customer damage

          The fixing drawer will not latch correctly. The drawer may even pop out during copying. The fixing drawer latches will not catch on the bearings mounted on internal rails correctly. Bearings and rails appear to be normal.

          the problem can be resolved onsite with no parts needed.
          Simply swap latches front to rear.
          The part number for the latches if this procedure doesn't work is FC6-8851-000.
          fixing.jpg
          **Knowledge is time consuming, exhausting and costly for a trained Tech.**

            Comment

            Previous template Next
            Working...