[Jamming] canon ir3300 bypass fails

[Guest]

[teckat]

Re: canon ir3300 bypass fails

what are the Jam codes ?? if any
check the flag of PS22 the multifeeder paper sensor
make sure the black plastic cam follower #13 on the right side of the lower door has not fallen off-will prevent the flag of PS22 the multifeeder paper sensor from reaching the sensor when the door was closed.
ir2800cam.jpg


Pickup from the multifeeder tray fails /does the pickup roller rotate) ??
Multi-feeder paper sensor (PS22)
Place paper in the multifeeder.
Does bit 5 change from ‘0 to ‘1’? (service move COPIER>I/O>DC-CON>IO-PO16)
NO: Check the wiring and the link; if normal, replace the sensor.
Multi-feeder clutch (CL2), DC controller PCB-
Execute the following in service mode: code 2 of COPIER>FUNCTION>PATH-CHK>CL; i.e., CL-ON. Is the clutch drive signal present between J302B-7 and -8 of the DC controller PCB? (J302B- 7: 24 V, J302B-8: MLT_CL)
YES: Check the wiring; if normal, replace the clutch.
NO: Replace the DC controller PCB.

Pickup from the multifeeder tray fails/ does the multifeeder holding plate fail to move up) ??
Execute the following in service mode: code 4 of COPIER>FUNCTION>PART-CHK>SL; i.e., SL-ON. Is the solenoid drive signal present between J308A-1 and -2 on the DC controller PCB? (J308A- 2: 24 V, J308A-1: MLT_SL)
YES: Check the wiring and the link; if normal, replace the solenoid.
NO: Replace the DC controller PCB.