[Jamming] ADF jammed

[mezerwi]

Hi guys,

Its IR8500 ADF which always jam. Checked under SM, shown jam code 002A. Seems prob with skew. Any idea?

Thanks,
Mezerwi

[teckat]

Re: ADF jammed

Hi guys,

Its IR8500 ADF which always jam. Checked under SM, shown jam code 002A. Seems prob with skew. Any idea?

Thanks,
Mezerwi

002A =1st sheet pickup leading edge skew --- Sensor S4/S5
U need to inspect the DF for any blockage
Check Pickup roller/ Feed R & Separation belt

FEEDER>FUNCTION
SENS-INT
Use it to adjust the sensitivity of each sensor of the ADF.
Be sure to clean the sensor before executing the mode.
1) Select the item, and press the OK key.
2) See that the machine stops automatically after making adjustments.

BLT-CLN (iR8500)
Use it to clean the separation belt of the ADF.
<Using the Mode>
1) Select the item, and press the OK key.
2) See that the separation belt goes ON. Press the Stop key to stop it.

REG-CLN (iR8500)
Use it to clean the registration roller of the ADF.
<Using the Mode>
1) Select the item, and press the OK key.
2) See that the registration roller starts to rotate. Press the Stop key to stop
it.

[mezerwi]

Re: ADF jammed

Thanks, it work out perfectly.

[teckat]

Re: ADF jammed

Thanks, it work out perfectly.

thanks

where u been for three months ???

[mezerwi]

Re: ADF jammed

thanks

where u been for three months ???

Problem solved by itself before.

Then it happen again, so i search for old post.

I'm new with 8500, plenty to learn from.