IR2200 2nd side cross feed reg problem

[blackcat4866]

Re: IR2200 2nd side cross feed reg problem

Thanks for following up. Congratulations. =^..^=

[Brian8506]

Re: IR2200 2nd side cross feed reg problem

Replaced horizontal reg motor and that fixed it.

[Brian8506]

Re: IR2200 2nd side cross feed reg problem

I believe there is a sensor but it doesnt usually get dirty. If I'm right its on one end of the pfu by the motor. I played with that df adjustment. It helped copy thru df but off glass and print doesnt change. I'm gonna go back with a motor and try my luck.

[blackcat4866]

Re: IR2200 2nd side cross feed reg problem

I can't remember if the iR3300 has a horizontal registration sensor. It was really common on NP-3030, NP-3050, and NP-4050 to have toner dump into that optical sensor. As a consequence the horizontal registration motor always ran all the way to the end. Now it surprises me that you don't see the effect on the first side, but I suppose it's possible.

The only thing that pops up in the database is a separate adjustment for DADF main scan registration, second side. =^..^=

[Brian8506]

Single sided is fine. When doing 2 sided from glass, thru adf or mailbox 2nd side off about 1/4 inch in the cross feed direction. Thats after adjusting adj-refe to -50, the highest setting. I'm suspecting horizontal reg motor m3 but havent gotten e051 codes. Wondering if any of you have had this. TIA