Canon ira c5051i

[godyng]

Re: Canon ira c5051i

Must be the HDD problem !

[COPIERTEC ASSOCIATES]

Re: Canon ira c5051i

personally I would reset my main controller and RAM first.
If that did not work I would do a full overwrite of the firmware.
If problems still persisted I would do a DCON and then an MN-CON clear

I do agree with Charm.I had a similar fault on an IR6000 and the fault was cleared after re-installing the system firmware.

[dickiebob]

Re: Canon ira c5051i

If 2nd delivery full sensor flag is mistakely removed during buffer pass unit instalation, sensor keeps reporting tray "C" full state. Reports and P prints etc are printed to "C" output tray by default. If this is the problem in your case then you probably can't execute auto gradation adjustment...

[ATTACH=CONFIG]17067[/ATTACH]

Thanks - auto grad is fine and feeds to the c TRAY - but it is worth a look.

[roller]

Re: Canon ira c5051i

yes it does - will try. Whats your thinking?

If 2nd delivery full sensor flag is mistakely removed during buffer pass unit instalation, sensor keeps reporting tray "C" full state. Reports and P prints etc are printed to "C" output tray by default. If this is the problem in your case then you probably can't execute auto gradation adjustment...

buffer.jpg

[dickiebob]

Re: Canon ira c5051i

Do you have finisher attached to this machine? Try to change the output tray for "other" in user mode Function Settings > Common > Paper Output Settings to tray A or B.

yes it does - will try. Whats your thinking?

[roller]

Re: Canon ira c5051i

Do you have finisher attached to this machine? Try to change the output tray for "other" in user mode Function Settings > Common > Paper Output Settings to tray A or B.

[dickiebob]

Re: Canon ira c5051i

[ATTACH]17061[/ATTACH]

Thank you!

[zoraldinho]

Re: Canon ira c5051i

Apologies - but what is self test?

gen-850.pdf

[dickiebob]

Re: Canon ira c5051i

I will try mncon clear. To be honest I had to leave it as it is working fine as far as the customer is concerned, unless it needs to print a report.

[dickiebob]

Re: Canon ira c5051i

Apologies - but what is self test?

[charm5496]

Re: Canon ira c5051i

personally I would reset my main controller and RAM first.
If that did not work I would do a full overwrite of the firmware.
If problems still persisted I would do a DCON and then an MN-CON clear

[zoraldinho]

Re: Canon ira c5051i

Did you perform self test??

[dickiebob]

Re: Canon ira c5051i

No paper deck, printing from the top tray of 4. It is very odd - the machine works perfectly fine for print and copy. Problem only shows when it needs to print any sort of a report, then it feeds the paper to reg rollers, hangs for about a minute and throws a jam. When you clear the jam the machine just hangs until you clear the report in the job log and does not allow any other prining or copying until you do so.

[zoraldinho]

Re: Canon ira c5051i

do not assume that just because it is new that the firmware was upgraded to the latest before it was delivered to you.

do you have a paperdeck attached to this machine by chance?
which tray is the report paper printing from?

I thought the same but hanging for two minutes?

[charm5496]

Re: Canon ira c5051i

do not assume that just because it is new that the firmware was upgraded to the latest before it was delivered to you.

do you have a paperdeck attached to this machine by chance?
which tray is the report paper printing from?