i need same help, we have Canon 7095 which was running fine this morning when it got a paper jam in one of the trays. I cleared the jam. now paper wont feed out of the paper tray, all 4 paper tray. any idea what going on here?
-
-
Re: Canon 7095 paper won't feed
==============================
open the front door of the copier and pull out Unit 1, Unit 2 and all paper supplies. Then check for jammed paper behind the devices. Make sure the frame connectors are free of any bits of paper or pin damage.
is there a message of "Suspended" is displayed on the Control Panel.
The problem may lie within the stapler cable, Finisher Controller or Stapler Unit (check this first).
A message of Suspended may indicate a communication problem between the Finisher and the Copier. Remove the Finisher, and see if a copy can be made. If a copy can be made with no message displayed, suspect a problem with the Finisher.
In some cases adjusting the Sensor Intensity for the Finisher has remedied the message. This procedure can be found in the Finisher- V1 / Saddle Finisher- V2 Service Manual, Pg; 4-6 and 4-7, of the Finisher - V1 Service Manual, or Pg; 4-7, 4-8 of the Saddle Finisher - V2 Service Manual. It should also be noted that the sensor intensity should be adjusted upon installation of the Finisher, or replacing specific sensors.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: Canon 7095 paper won't feed
How about pickup from the Stack Bypass Tray, does it work ?
If yes, suspect the Papaer feeding Timing Belt is broken (at the rear inside the machine).Comment
Comment