ADV 5030 copy problem

[diguo741]

I use feeder copy picture as this , so i don't know what's problem , everyone who can help me , thank you.
11_副本.jpg22_副本.jpg

[teckat]

Re: ADV 5030 copy problem




u mean the dip in line

Run STRD-POS in service mode under >
Copier-Function-Install-STRD-POS. This will adjust the automatic detection of CCD scanning position in DF stream reading.
Running this adjustment may correct the issue.

[diguo741]

Re: ADV 5030 copy problem

u mean the dip in line

Run STRD-POS in service mode under >
Copier-Function-Install-STRD-POS. This will adjust the automatic detection of CCD scanning position in DF stream reading.
Running this adjustment may correct the issue.

I mean the top line is not straight ,have the winding ,anyway thanks for you to tell me how to do ,i will try !

[canonbundy]

Re: ADV 5030 copy problem

I use feeder copy picture as this , so i don't know what's problem , everyone who can help me , thank you.
[ATTACH=CONFIG]20533[/ATTACH][ATTACH=CONFIG]20534[/ATTACH]

Check in the Installation Manual for adjustments, looks like the DADF is too high on the rear left side.

[THUK]

Re: ADV 5030 copy problem

+ 1 on last comment.

[teckat]

Re: ADV 5030 copy problem

+ 1 on last comment.

==========================

Height Adjustment
--------------------DF HEIGHT ADJ-.pdf

[diguo741]

Re: ADV 5030 copy problem

==========================

Height Adjustment
--------------------[ATTACH]20588[/ATTACH]

thank you very much ,i will try!

[diguo741]

Re: ADV 5030 copy problem

+ 1 on last comment.

thank you ! i will try

[diguo741]

Re: ADV 5030 copy problem

Check in the Installation Manual for adjustments, looks like the DADF is too high on the rear left side.

thank you ! i will try ~