I noticed in the LFP Troubleshooting Guide V2.0 that they mention checking the gap of the purge unit in two places. They mention checking the gap but don't mention how to adjust it if it is out of spec Here is the page from the guide - it is "T11 Ink Supply Fault Isolation Tool" on page 4-15.
Can someone describe how to perform the adjustments - in my case the head to cap gap (Photo 3) is the one I am most interested in.
Capture.jpg
Can someone describe how to perform the adjustments - in my case the head to cap gap (Photo 3) is the one I am most interested in.
Capture.jpg