Randomly I am getting "Load Paper" on one of the 3 drawers of Multi-drawer A1.
When this happens I cannot open drawer by pushing the button - so I have to open using a flat screwdriver from the side.
Of course the paper is lifted up when this happens.
Than I push back in, the paper lifters go down and than up and then it is ready.
I have cleaned the sensors. I also checked that the sensors have that white plastic against charging.
Ideas ?
sensor type.jpg
When this happens I cannot open drawer by pushing the button - so I have to open using a flat screwdriver from the side.
Of course the paper is lifted up when this happens.
Than I push back in, the paper lifters go down and than up and then it is ready.
I have cleaned the sensors. I also checked that the sensors have that white plastic against charging.
Ideas ?
sensor type.jpg