IR5065

[vigour]

Re: IR5065

How about an RCON clear after making sure you have the values to input again,

Did anyone clean the CIS glass?
I would remove, inspect, clean CIS
and replace it, if that did not work.

Is there a spring mod for IR ?
I only know of one for Advance feeders

[teckat]

Re: IR5065

This is an IR5065. It has additional functions mode. Settings/Registration is on Advance series. Nothing under additional functions that will disable this

setting is enabled when combining with the following versions: RCON v3.01 (or later) + ADF v4.01 (or later).

System v56.01.01 V3

RCON=v6.01 [iR5055/5065/5075]

DADF-S1 /BW_DFR1 /v5.01 (Controller) DL Tool is required (service tool (downloader PCB: FY9-2034) is needed.

[Brian8506]

Re: IR5065

That's the version we installed. Everything installed fine. I think it has to do with whatever reads the glass for dust. Gonna have to look at the manual for a change. Not an urgency as cust rarely does 2 sided but still want to fix it. We'll get it eventually.

System v56.01.01 V3

RCON=v6.01 [iR5055/5065/5075]

DADF-S1 /BW_DFR1 /v5.01 (Controller) DL Tool is required (service tool (downloader PCB: FY9-2034) is needed.

[teckat]

Re: IR5065

That's the version we installed. Everything installed fine. I think it has to do with whatever reads the glass for dust. Gonna have to look at the manual for a change. Not an urgency as cust rarely does 2 sided but still want to fix it. We'll get it eventually.

Dust Detection in Stream Reading Mode
Printer uses the dust detection control mechanism to check for dust on the platen glass and the ADF platen
roller.

Memory PCB = data delivery between main controller and reader contoler/ADF

has connection to ADF>, Reader Pcb>,& Main Pcb