Guys,
I really need help on this big time
This W8400 has the latest firmware updates
And was printing ok
print heads are good!
The print head looks like it was not filling some of the inks
and it was starting to print bands
found out the seal was not firm on the print head and was not developing the vac needed to pull
ink
I did a "Move Printer" and drained all ink
and made sure there were no clogging anywhere
Went into the
Fill Ink mode and all was good
the print head was drawing the ink thru the tubes just fine!
But it then went thru the ink fill cycle and it will freeze mid cycle on the bar graph every time
But ink head is full
it just will freeze
The pring head is over the drain and just stays there !
I have to unplug it every time and let it sit
go back into service mode
I cant get out of "ink fill" mode
It restarts every time.
Is there a general reset of the eprom or program to cancel this ??
Please help
I really need help on this big time
This W8400 has the latest firmware updates
And was printing ok
print heads are good!
The print head looks like it was not filling some of the inks
and it was starting to print bands
found out the seal was not firm on the print head and was not developing the vac needed to pull
ink
I did a "Move Printer" and drained all ink
and made sure there were no clogging anywhere
Went into the
Fill Ink mode and all was good
the print head was drawing the ink thru the tubes just fine!
But it then went thru the ink fill cycle and it will freeze mid cycle on the bar graph every time
But ink head is full
it just will freeze
The pring head is over the drain and just stays there !
I have to unplug it every time and let it sit
go back into service mode
I cant get out of "ink fill" mode
It restarts every time.
Is there a general reset of the eprom or program to cancel this ??
Please help