settings not allow changes
Here is an odd thing that I mentioned before. When the new DC-PCB was installed the only setting that I couldn't set was the D-PRE-TR. The new setting is +12. The old was +14. I make the change, cycle the power and then recheck and it will have returned to +14.
HV-TR > D-PRE-TR > +12
Now, there is another setting that I tried to change and it did the same thing, in fact, I couldn't even scroll to the next page and back without it resetting to the original value.
OPTION > BODY > IDL-MODE > 3
It is currently set to 1 and I have been trying to set it to 3 to see if it affects a change.
In both circumstances I'm able to make other changes within the same area and have them hold.
Ideas???
Here is an odd thing that I mentioned before. When the new DC-PCB was installed the only setting that I couldn't set was the D-PRE-TR. The new setting is +12. The old was +14. I make the change, cycle the power and then recheck and it will have returned to +14.
HV-TR > D-PRE-TR > +12
Now, there is another setting that I tried to change and it did the same thing, in fact, I couldn't even scroll to the next page and back without it resetting to the original value.
OPTION > BODY > IDL-MODE > 3
It is currently set to 1 and I have been trying to set it to 3 to see if it affects a change.
In both circumstances I'm able to make other changes within the same area and have them hold.
Ideas???
Comment