Hi guys
Any info on the above gratefully received. Replaced the printhead on the 750 today. No experience on these but did it by the book and it seemed to be fine and went though the ink refilling procedure etc. Problem is its only printing in mono. No colour is coming out. When I do the nozzle check or colour palette test prints there is no colour at all just the black and greys. Its not flagging up any errors and I don't know the history of the machine. The error log was showing codes 03800500-2F30/2F40/2F41. This points to a non-discharging error? possibly to do with the head management unit? I think it has not been used for a while and has been left in a store room so I've been asked to try and get it going again.
Any info/advise at all would be a massive help.
Much obliged...Dave
Any info on the above gratefully received. Replaced the printhead on the 750 today. No experience on these but did it by the book and it seemed to be fine and went though the ink refilling procedure etc. Problem is its only printing in mono. No colour is coming out. When I do the nozzle check or colour palette test prints there is no colour at all just the black and greys. Its not flagging up any errors and I don't know the history of the machine. The error log was showing codes 03800500-2F30/2F40/2F41. This points to a non-discharging error? possibly to do with the head management unit? I think it has not been used for a while and has been left in a store room so I've been asked to try and get it going again.
Any info/advise at all would be a massive help.
Much obliged...Dave
Comment