Hello everyone!
I have an error c2454, i tried to change the developer unit with an developer unit from another c6500 and the problem was not resolved so this means that the developer unit that i had was ok. When i check sensor output the K values at speed 1 & speed 2 are ok but at speed 3 the values goes to 255. Does someone know why happening this? I tested the motors and the motors works fine.
Regards,
Dorian
I have an error c2454, i tried to change the developer unit with an developer unit from another c6500 and the problem was not resolved so this means that the developer unit that i had was ok. When i check sensor output the K values at speed 1 & speed 2 are ok but at speed 3 the values goes to 255. Does someone know why happening this? I tested the motors and the motors works fine.
Regards,
Dorian