bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Ad3t0
    replied
    Re: bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

    WORKING! It was the unit that holds the coronas there must have been something wrong with it thank you!!!

    Leave a comment:


  • Woxner
    replied
    Re: bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

    hope that the side with the blanks has not damaged the drum.

    Leave a comment:


  • Ad3t0
    replied
    Re: bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

    Originally posted by Woxner
    forgot the screws on the guide will come loose and do this too. but if its an old assy replace it
    Thanks for the tip I'll be looking into it right away! I'll post back if it works out.

    Leave a comment:


  • Woxner
    replied
    Re: bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

    forgot the screws on the guide will come loose and do this too. but if its an old assy replace it

    Leave a comment:


  • Woxner
    replied
    Re: bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED

    replace the transfer corona assy. it is more then just the wires. look likes it dropping off

    Leave a comment:


  • bizhub 601 missing print on lower part of an 8-1/2x11 PIC INCLUDED



    Iv'e replaced the drum, drum blade, all the corona wires and cleaned out and replaced the developer and its MUCH better than before but now I see there's a little problem on each page towards the bottom where nothing will print. What part should be replaced or what can I do to solve this?


    Thanks ahead of time for any help or input! Looks like an awesome community!





    Attached Files
Working...