I am working on a bizhub 420 (similar to bizhub 360) and I need to separate the finisher assy from the main body to clean the whole thing (machine to be refurbished) and I've unscrewed so many screws without success I am in the shop now and getting a little desperarte about this. (Machine due to be delivered Monday).
-
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
which finisher? do you need a manual?We know a thing or two because we've seen a thing or two.
The medication helps though... -
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
The finisher is the FS-510
I just want to know if theres an easier way to disengage the trays assy from the machine. Thanks.
konica-minolta-bizhub-420.jpgComment
-
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
These finishers are really awkward to handle. IIRC there are no actual screws holding the finisher to the MFP, but the bridge stays attached to the finisher tray assembly. Pull the whole finisher/bridge forward a few centimeters from the base machine then slide it out to the left. The only way to set it down is on it's back.
It's heavy and awkward. It helps to have a friend help you lift it. You cannot lift by the trays or by the bridge only or something will break.
On one particular machine, I had an enduser who kept pulling the finisher forward until the paper paths did not align, then it would jam. Eventually I drilled and tapped two holes, and screwed the finisher to the machine so they would not do it any more. AFAIK that was the single only machine ever to have screws, because I installed them. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
isnt that the one with the square hole you push a screwdriver in and it releases the hooks that latch it on?
hole.jpgWe know a thing or two because we've seen a thing or two.
The medication helps though...Comment
-
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Comment
-
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
these machines were discontinued 2 years ago.Comment
-
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Comment
-
Re: Separating a Finisher tray assy from a bizhub 360/420 ideas?
discontinued 04/2015 here across the pondWe know a thing or two because we've seen a thing or two.
The medication helps though...Comment
Comment