C6000L tray 2 lift

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Phil Walling
    Technician
    • Dec 2015
    • 39
    #1

    C6000L tray 2 lift

    Morning Folks,

    Hope your all good.

    Something that has been baffling my brain. We have an issue with tray 2 not lifting. Everything points to the tray lift motor. Except... its not the motor. We have changed the lift motor.

    All I can think of is the very unlikely possibility that the frame has been bent by my customer slamming in the drawer? I am however clutching at very small straws!

    Anyone have any ideas?
    Tags: bent, customer, lift, motor, tray
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22696
      #2
      Re: C6000L tray 2 lift

      Machine trays or PF unit?

      There's a linkage that drives the tray upward ... if that linkage breaks the machine will try lifting for 5 seconds, then reverses and gives up. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • Phil Walling
          Technician
          • Dec 2015
          • 39
          #3
          Re: C6000L tray 2 lift

          Sorry Blackcat, been manic!

          Its the machine trays. All the linkages look ok.

            Comment

            Previous template Next
            Working...