C1070 registration swaying.

[MVPunisher]

I have a c1070 that the entire image is swaying back and forth in the feed direction during printing. Classic registration clutch symptoms. However I have replaced conveyance clutch and pre-reg clutch already. Thinking conveyance drive board. Anybody seen this?

Thanks

[Toxic]

Re: C1070 registration swaying.

Try to disable registration swing and check is there some improvements.
On C1060l dipsw for this is 36-3

[tsbservice]

Re: C1070 registration swaying.

Try to disable registration swing and check is there some improvements.
On C1060l dipsw for this is 36-3

Yes, not familiar with this model but would say to try adjustments of registration amount/loop through the service mode and see if it helps. Good point Toxic.

[MVPunisher]

Re: C1070 registration swaying.

Heard a couple stray clicks going on. Found registration idler gear on front of conveyance unit had some worn teeth. Replaced the gear and all is fixed. Thanks guys.

[blackcat4866]

Re: C1070 registration swaying.

Heard a couple stray clicks going on. Found registration idler gear on front of conveyance unit had some worn teeth. Replaced the gear and all is fixed. Thanks guys.

Which gears? =^..^=