Hello!
i have a used Bizhub pro C500, and CF5001.
Colours on prints of CF5001 are much more intensive, espessially red.
i try to replace drums, developer, recalibrate, search in forums and do all recomendations about "orange problem".
when i install dev units from CF5001 to C500, red is good, but after 200-300 prints it become "as usual" - orange.
then i took a color registration assy from CF5001 and install it to C500 - colours become slightly more intensive, but after recalibration effect is gone.
in scans green arrow is direction of moving of paper in copier.
near the edges, or near the white symvols or rgaphics density of "red" is nearly normal.
Thank you very much!
i have a used Bizhub pro C500, and CF5001.
Colours on prints of CF5001 are much more intensive, espessially red.
i try to replace drums, developer, recalibrate, search in forums and do all recomendations about "orange problem".
when i install dev units from CF5001 to C500, red is good, but after 200-300 prints it become "as usual" - orange.
then i took a color registration assy from CF5001 and install it to C500 - colours become slightly more intensive, but after recalibration effect is gone.
in scans green arrow is direction of moving of paper in copier.
near the edges, or near the white symvols or rgaphics density of "red" is nearly normal.
Thank you very much!
Comment