Bizhub 754e Tearing Pages in Finisher

[frd909]

Hi, I am having an issue with a clients 754e. It only occurs on some days, but when it does, it will last the day.

The first job, where the finisher has the pages outputting to the left side, outputs fine. The second job, where the finisher shifts the job over to the right on the output tray, is where this occurs. It seems the last page doesn't get pushed out along with the 10 sheet stack so it sits quarter-way out under the new stack inside the finisher. When it does get pushed out, I guess the left arm hits it hard because its not in the center and puts a rip on the page.

Any ideas?

[blackcat4866]

Re: Bizhub 754e Tearing Pages in Finisher

Very common on the FS-534:

Pix here:
FS-534 alignment plate wearing.

Misfeeds (72-18, 72-17, 72-21, 72-19) with FS-534. The first set ejects properly. The second set skews, and the third set piles up upon the second. Set eject belts are out of time, skewing the sets. Paper cuts in the stapling tray shift guides may result, catching the paper, flipping corners. Re-time set eject belts. Disassembly is not necessary. If the regulating plates are damaged, remove stapling tray shift guides to replace, or temporarily file smooth paper cuts. Or replace regulating plates (1 ea: A3EPPP5P01, A3EPPP5V01, A3EPPP5X01, A3EPPP6301, A3EPPP6401, A3EPPP6501). If paper is curled before copying load paper with curl upward.
=^..^=