di450 toner fly on t & s charger

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Matoku
    Trusted Tech
    100+ Posts
    • Feb 2008
    • 172

    di450 toner fly on t & s charger

    this di450 dv and drum already changed. the transfer block always soiled with thin of toner.cause the back side of paper get dirty.after I clean the paper guide (with plastic insulator) only 1 copies then it dirty again.
    anyone know how to solve this problem.
    Last edited by Matoku; 10-05-2009, 06:47 AM. Reason: not complete
  • ck1
    Trusted Tech
    250+ Posts
    • Apr 2008
    • 485

    #2
    did you check the anti spill plate ???

    Comment

    • wcastelli

      #3
      Try cleaning the bias contacts on the back of the developer unit and the rear frame of the copier, then regrease with conductive grease.

      Comment

      • Darren King
        copiertech
        500+ Posts
        • Jul 2007
        • 652

        #4
        Lower the metal guide on the trans/sep corona
        Hope this helps
        Darren

        Comment

        • Matoku
          Trusted Tech
          100+ Posts
          • Feb 2008
          • 172

          #5
          thanks for your reply,
          the final solution is the t & S block I change.

          Comment

          • alexg
            Junior Member
            • Jul 2009
            • 9

            #6
            Developer rollers

            This model uses to have problems with separation between drum and developer roller, there are two rollers in both sides of the magnetic roller. Try to replace them. These rollers have to be new with each drum replaced.
            Good luck.

            Comment

            Working...