Bizhub C550 wich cant see finisher.

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ReoNeo
    Technician
    • Dec 2008
    • 25
    #1

    Bizhub C550 wich cant see finisher.

    Hello... Have a quistion regarding Bizhub C550.
    The problem is that the C550 cant see that a finisher Fs-517 is attached.
    Hope that someone can give me a hint regarding this issue.
    Tags: 517, attached, bad, bizhub, bizhub c550, c55, c550, copier, dipsw, finisher, firmware, issue, off, power, power supply, recognized, required, set, supply, support, upgrade, version
    • emujo
      Field Supervisor

      2,500+ Posts
      • Jun 2009
      • 3009
      #2
      The FS-517 is not recognized by the copier.
      Description:
      FS-517 finisher is not recognized.
      Solution:

      CAUSE: Outdated firmware. Firmware version 6B or higher is required to support the FS-517 or DIPSW 1 & 2 are set to OFF.

      SOLUTION: Upgrade the copier firmware to version 6B or higher. Also make sure DIPSW 1 and 2 on the TRCB is set to ON.

      Emujo
      If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

        Comment

        • MR CLEAN OC
          #3
          bad dc power supply.

            Comment

            • ReoNeo
              Technician
              • Dec 2008
              • 25
              #4
              Thank you, changed the power and ok.

                Comment

                Previous template Next
                Working...