C3B02 fault on Konicaminolta c452

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jrf
    Trusted Tech

    100+ Posts
    • Feb 2009
    • 142

    C3B02 fault on Konicaminolta c452

    Hi everybody,
    Has anybody had this fault, i am waiting for an IH power board which i hope will repair it but just wondering if you had any other cause of it.
    Thanks
  • KEVIN900
    Copier Ninja

    100+ Posts
    • Oct 2009
    • 200

    #2
    Hey jrf, the manual says to check, in this order; proper fuser installation, proper closure ( door latch ) of the right hand door, check around-all around-for wiring connection issues, change fuser, then coil, then IHPU, then PRCB, then REDB. If you have a trade-in, or lease return, at the shop; it might pay to do some parts borrowing.
    Kevin900

    Comment

    • oem

      #3
      In the cases we faced, we replaced the IHPU and the coil unit. We were told that the coil units were okay, so replacing the IHPU must be enough to recover.

      Comment

      • jrf
        Trusted Tech

        100+ Posts
        • Feb 2009
        • 142

        #4
        Thanks for replies, just to let you know the IH power supply sorted this problem but i also replaced the coil unit as it has blown on some C451 machines

        Comment

        • neunelf
          Junior Member
          • Mar 2010
          • 8

          #5
          hi

          i had this code 4 times! 3 times it was the IHPU board and 1time it was the fusing unit self.

          regards

          Comment

          • jrf
            Trusted Tech

            100+ Posts
            • Feb 2009
            • 142

            #6
            Was it the fuser or the coil unit neunelf ?

            Comment

            • neunelf
              Junior Member
              • Mar 2010
              • 8

              #7
              3 times the IHPU and 1time the fusingunit, NOT the coil. i didn't have a defective coil till today.

              greets

              Comment

              Working...