bizhubpro c6501

[thuo]

Hi,
have bizhub c 6501 warms up o.k. but from there does not come ready keeps on displaying stabilizing. new imaging units & transfer belt.any guess what could be the problem with the machine.doesnt display any error code.
thanks

[CT Copier Repair]

Firmware
or setup problem ie when new image units and or developer were replaced they were not set up correctly

but i'd try firmware first

[thuo]

Firmware
or setup problem ie when new image units and or developer were replaced they were not set up correctly

but i'd try firmware first

machine was working working o.k after replacing the parts .problem is keeps on running (stabilizing ) forever.any failure in related parts like transfer belt or pgc sensors.

[engineer]

is in display still "warming up"?

[1FRY1]

If it says "warmimg up" all the time then one of the three upper heater lamps has gone

check each one

[thuo]

BIZHUB C 6501

Hi all
thanks for you suggestions.problem was neither firmware or fuser unit related.
it was a malfunction of a pulse sensor
thanks

[Jsh77]

Re: bizhubpro c6501

Try to change:

65AA 5365 1 FIXING LIMITTER
A03U 7256 00 Fixing Regulating Shaft /A

I had a similar problem, machine was in warming up mode for a long time. Limitter was slipping...