[Error Code] C-2434 bizhub c6500

[jzheld]

C-2434 On initial adjustment of the TCR
sensor/K, when the control voltage
was minimal, TCRS/K
detected over specified value.
Printer control board (PRCB)
Developing motor/K (M23)
TCR sensor/K (TCRS/K)

don't know where to start, is that just not enough developer? I changed TCR sensor, changed corona as well, still the same, any suggestions?

[ineo+6501]

Re: C-2434 bizhub c6500

Change the Black developer

[jzheld]

Re: C-2434 bizhub c6500

Change the Black developer

Thanks will do it now

[empiru]

Re: C-2434 bizhub c6500

Exactly, you have to change the developer; I just wanted to tell you that I had the same code and after I changed the Black Developer, the other colors started popping out SC- codes for the TCR sensors... and I had no choice but to replace all the developers.

[jzheld]

Re: C-2434 bizhub c6500

Exactly, you have to change the developer; I just wanted to tell you that I had the same code and after I changed the Black Developer, the other colors started popping out SC- codes for the TCR sensors... and I had no choice but to replace all the developers.

did you replace just the developer? not developer tank?

[JustManuals]

Re: C-2434 bizhub c6500

This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

Paul@justmanuals.com

[jzheld]

Re: C-2434 bizhub c6500

Thanks for the help, I changed all the developers (needed to do soner or later) work perfect now