Bizhub 350 image problem

[kingarthur]

Re: Bizhub 350 image problem

Adjust the RADF according to the set up procedure, using a thin piece of paper, it works every time...

[Tata]

Re: Bizhub 350 image problem

Yup! Adjust DF height.

[mo0651]

Re: Bizhub 350 image problem

Look for missing spacers on the white plate that sits above the narrow slit glass when you are using the adf.

[brianho80]

Re: Bizhub 350 image problem

Thanks for the advise,

Will try do some testing again on adf and fuser

[Hansoon]

Re: Bizhub 350 image problem

The shown sample MUST be a copy through ADF. Nothing else is possible. I cannot imagine that paper moves laterally during the copy transfer process.

The ADF is mis aligned and/or the height must be readjusted with the screw on the left hinge so the white guide plate lays flat on the glass.

Hans

[acusso1234]

Re: Bizhub 350 image problem

Are you sure it is not a copy done using the Automatic Document Feeder (ADF)?
Seen this when adf is not parallel to the scan area.
If really it is a print, then ceck fuser unit entrance guide for foreign things like toner melted and clean the registration roller as well.

[brianho80]

Hi Expert,

Does anyone what happen to the machine according to the image?

i had tested print from demo page / PCL font print and PCs; nothing happen.

It happen intermittent and only happen when customer doing printing, not happen when technician was there to do testing.

anyone can advise?

problem image.JPG