BH 223/283/363/423 Fuser rebuilds

[gitana1983]

Re: BH 223/283/363/423 Fuser rebuilds

There is 3de party thermistors available for BH224 that works fine. Bad toner is a killer on the upper roller.

Can't find a vendor that carries them, can you point me in the right direction?

[allan]

Re: BH 223/283/363/423 Fuser rebuilds

Im out here in ZA i get them from an after market importer that won't disclose this info. Get the BH250 ones and modify the wiring to work with the connector.

[avio2]

Re: BH 223/283/363/423 Fuser rebuilds

I've found heat rollers at Katun, but have not found heat roller claws yet. These fusers typically last 240K before the heat roller peels at the claws. I believe that the pressure roller and bearings will last the full 480K.

Does anybody know a part number for a compatible hr claw, and/or a source? =^..^=

the katun roller do not last more than IR

[avio2]

Re: BH 223/283/363/423 Fuser rebuilds

Im out here in ZA i get them from an after market importer that won't disclose this info. Get the BH250 ones and modify the wiring to work with the connector.

but fuser as'y bh 250 are completely different

[avio2]

Re: BH 223/283/363/423 Fuser rebuilds

but fuser as'y bh 250 are completely different

excuse me
i have read bad
thermistor with modify connector is ok

[hoyko]

Re: BH 223/283/363/423 Fuser rebuilds

Are you sure the BH3510/350 upper fusing roller will work in the BH363/423 series fuser units?

[Don N.]

Re: BH 223/283/363/423 Fuser rebuilds

UFR is same for 2010/2510/3010/3510/200/250/350/222/282/362/223/283/363/423. Press seems to go multiple rebuilds in past 3510 & 350 series.
I have some with one of the two lamp's filament broken, & warm up failure codes. Looking into using lamps from previous series since they are plentiful from trade-ins. Will have to modify the holders and splice/solder the wires, but that's why we are called tech's.