BH751 w/ Hole Punch Issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • AVux07
    replied
    Re: BH751 w/ Hole Punch Issue

    Problem was with the Finisher Cont. Bd, replaced it and it's fixed.

    Leave a comment:


  • AVux07
    started a topic BH751 w/ Hole Punch Issue

    BH751 w/ Hole Punch Issue

    This machine will intermitely not hole punch the right number of holes, select 3 holes and you may get 2 towards the middle. It's a FS-524 w/ a PK-505 hole punch. I reloaded the MF and FIN firmware though not the PK firmware. When it starts doing this I reset both power sw's and it'll work ok for a few sets then start back. Any ideas, Thanks
Working...