Anyone know how to 'disable' or 'turn off' Color Management on a Rip using a Creo ColorServer?
I want make some custom ICC Profiles and before sending the targets, you have to disable ALL Color Management. So that the data is printed 'AS IS' without ANY adjustments.
ICON CPP650 w/ ICON PowerPro Plus v2.0 15-May-2008
Cheers,
Topstep1
please look at page 2 of this PDF attachment. If there an Engine Mode on KMs that will allow for a Calibration mode? (not the regular call in the interface)
"The engine was set-up following the procedures set forth in the Advanced Production Print Training Program. Engine calibration was selected and initiated after 25 warm-up sheets were run."
I want make some custom ICC Profiles and before sending the targets, you have to disable ALL Color Management. So that the data is printed 'AS IS' without ANY adjustments.
ICON CPP650 w/ ICON PowerPro Plus v2.0 15-May-2008
Cheers,
Topstep1
please look at page 2 of this PDF attachment. If there an Engine Mode on KMs that will allow for a Calibration mode? (not the regular call in the interface)
"The engine was set-up following the procedures set forth in the Advanced Production Print Training Program. Engine calibration was selected and initiated after 25 warm-up sheets were run."