Like the title says it's squeaking near the fuser I've done everything I can find it but just can't seem to get it. I do not think it's coming from the fuser itself. Any suggestions would be greatly appreciated. Never had a squeaking problem like this before...
Annoying Konica Minolta Bizhub C360 squeak...
Collapse
X
-
-
Re: Annoying Konica Minolta Bizhub C360 squeak...
I had a squeak in one of these and it turned out to be the registration assembly. I had to remove it and lube the bushings. That solved the problem.
Hope this helps
DarrenComment
-
Re: Annoying Konica Minolta Bizhub C360 squeak...
Hard to diagnose a squeak unless you are there to hear it.
Try swapping fuser.
Otherwise I tend to start removing a gear that drives a particular unit and see if it goes away when that unit loses drive. sometimes a trick if it only does it while copying, but listen close before it jams...lolComment
-
Re: Annoying Konica Minolta Bizhub C360 squeak...
Squeaks are really my least favorite / easy thing to fix! Little ventriloquist inside the machine makes it tough to even go by where it 'sounds' like it's coming from!! I agree, isolation is key!Comment
-
Comment
-
Re: Annoying Konica Minolta Bizhub C360 squeak...
Check recycle of transfer belt. There are several versions of belt fighting toner blocking recycle pipe.
BRI'll never ask if I didn't check user manual, service manual, parts list, BSI/TNI/TAD... web, existing threads.Comment
Comment