Kyocera 3010I doc. feeder troubles..

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • jper34
    Trusted Tech

    Site Contributor
    100+ Posts
    • Sep 2011
    • 225
    #1

    Kyocera 3010I doc. feeder troubles..

    Hey Folks,
    have a customer with a 3010I series, and the document feeder, intermittantly willjam..I noticed the lower plate not always lift up...I removed solinoid, clean and put a drop of oil on the plunger...worked for a little bit...has anyone encountered this trouble..?
    I'm guessing I need to order a solinoid, but thought I'd check for any other input..?

    Thanks,
    Jaime
    I.C.S.
    CT.
    Tags: 3010i, feeder, guessing, solinoid, trouble
    • mincopier
      Trusted Tech

      250+ Posts
      • Dec 2015
      • 290
      #2
      Re: Kyocera 3010I doc. feeder troubles..

      Check the width sensors on the feeder. They are attached to the front and rear guides underneath. Have sent the contacts get dirty and not read the proper size paper.

        Comment

        • jper34
          Trusted Tech

          Site Contributor
          100+ Posts
          • Sep 2011
          • 225
          #3
          Re: Kyocera 3010I doc. feeder troubles..

          Originally posted by mincopier
          Check the width sensors on the feeder. They are attached to the front and rear guides underneath. Have sent the contacts get dirty and not read the proper size paper.
          would that cause the lifer plate, to not lift?, whats happening, is that lifter plate doesnt rise up, so the pick up rollers spin, but the paper is too low position, to grab the paper.

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 22619
              #4
              Re: Kyocera 3010I doc. feeder troubles..

              Oiling a solenoid is the surest way to make it misfire. Start by soaking out both parts in alcohol then cleaning the bore with a Q-tip. =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                • ntbann
                  Senior Tech

                  500+ Posts
                  • Jan 2012
                  • 596
                  #5
                  Re: Kyocera 3010I doc. feeder troubles..

                  Just had one that the post snapped off the lift plate. Not a good design.

                    Comment

                    Previous template Next
                    Working...