Imagistics IM2520/Konica MinoltaDI 2510

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Jerry
    • Jan 2025
    #1

    Imagistics IM2520/Konica MinoltaDI 2510

    Have not seen problem in person, another tech called me and asked to post. Display has lines 1/16\" wide running horizonal and vertical. You can barely read the wait warming up and when ready you can\'t see anything. It will not copy, everything is locked up. He has replaced the complete opp panel from a good working machine, same problem. The hot line had him change the main board, same problem. He also unhooked all options, same problem. Anyone seen this befor? Thanks guys for any help.
    Tags: 2510, 510, 520, back, di251, di2510, every, help, hot, im2520, imagistics, konica, konica minolta, konica minolta di251, kyocera, locked up, main, main pcb, minolta, pcb, person, pinched, tech, unit, wait warming up, warming up, wire, wiring
    • 10871087
      Service Manager

      1,000+ Posts
      • Jan 2005
      • 1144
      #2
      Re:Imagistics IM2520/Konica Minolta DI2510

      Seen something like it on a Kyocera machine a few years ago. It ended up being a pinched wire. I would look closely at the wiring from the op unit back to the Main PCB.

        Comment

        • Jerry
          #3
          Re:Imagistics IM2520/Konica Minolta DI2510

          Found problem, the controller board that sits on top of the MFB was bad.

            Comment

            Previous template Next
            Working...