FULL BLACK PAGE on kyocera FS-3140

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • ranachinna
    replied
    Re: FULL BLACK PAGE on kyocera FS-3140

    Originally posted by copycoan
    same problem "adding toner" i tried drive unit, etc.. i changed a gear GEAR DLP Z31H (bulletin Measures against the Developer Drive Gear Shaft Twist), gears on dev unit dont rotate properly, check out with door open and with no toner, finally it loaded toner and start working.

    If you check toner inside one gear is there then you can swap that one

    All the best keep going on

    Leave a comment:


  • copycoan
    replied
    Re: FULL BLACK PAGE on kyocera FS-3140

    same problem "adding toner" i tried drive unit, etc.. i changed a gear GEAR DLP Z31H (bulletin Measures against the Developer Drive Gear Shaft Twist), gears on dev unit dont rotate properly, check out with door open and with no toner, finally it loaded toner and start working.

    Leave a comment:


  • Tropico19
    Guest replied
    Re: FULL BLACK PAGE on kyocera FS-3140

    Hey , Laurent19
    I have the same problem and no solution .I tried in addition to changing the main board and the THT board without any success .

    BiG problem !

    Leave a comment:


  • tmaged
    replied
    Re: FULL BLACK PAGE on kyocera FS-3140

    It has to be high voltage arcing to cause it. make sure the drum is slid in & latched.

    Leave a comment:


  • Max
    replied
    Re: FULL BLACK PAGE on kyocera FS-3140

    Check the charge/grid bias connectors on the printer side. Possibly dirty or arcing.

    Leave a comment:


  • LAURENT19
    started a topic [Electrical] FULL BLACK PAGE on kyocera FS-3140

    FULL BLACK PAGE on kyocera FS-3140

    I've Suddently full Black Pages on FS-3140 .

    -------------------------------------------------------

    The printer indicate NOW

    " add toner please wait" but the cartridge TK350 is FULL and

    The WASTE TONER BOTTLE continues to fill.

    --------------------------------------------------------------
    FOR TESTING

    I've change :

    - the development Unit
    - the Drum Unit
    - and a new Waste toner bottle

    After 10 min,
    The printer indicate always " add toner"
    And the waste toner is FULL AGAIN.


    I think a THT Problem OR Main Card.

    Thanks a lot for your ideas
Working...