KIP 860 E-0722

[Tech09]

have you leveled with the precision water level?

Ah, great point!

[JR2ALTA]

have you leveled with the precision water level?

[Tech09]

Oh sorry for the delay! Didn't see your post. My belt was never moving, it always stayed in center, it was just the sensor getting dirty that always triggered the error code, Are your bearings fully seated properly?

[Bricorley]

what was the fix? I have a 860 flipping from LT / RT skew. The belt keeps moving no matter how much i adjust the tension

[Tech09]

I have an 860 that used to E-0722 codes, transfer belt skew right side. At first I would grab another tech and actually pull the belt out and clean the sensor but by second time that happened we looked at how to prevent this so we took a static brush from Konica Minolta RU and cut two little pieces and attached them to the right side skew sensor bracket with the brush side towards the belt. The brushes aren't actually touching the belt. While this hasn't completely fixed the issue, it has certainly reduced the frequency the error occurs. Now I open the front and clean the sensor off with canned air and a toothbrush.