Set toner waste container

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • TONERINMYNOSE
    Trusted Tech
    • Aug 2010
    • 114

    #1

    Set toner waste container

    After replaceing the drv and spc boards (we had to borrow them to repair another machine) the machine keeps displaying this message, we checked all connectors, and even replace the sensor for phone, i know its something dumb, any ideas?
  • mkb
    Technician
    • Sep 2010
    • 23

    #2
    What kind of copier?

    Comment

    • TONERINMYNOSE
      Trusted Tech
      • Aug 2010
      • 114

      #3
      LOL DP-8045

      Comment

      • mkb
        Technician
        • Sep 2010
        • 23

        #4
        Did you unplug the senor by the main motor (fly wheel area)

        Comment

        • Luong Nam
          Technician
          • Oct 2009
          • 49

          #5
          Check harness of toner waste container sensor.

          Comment

          • TONERINMYNOSE
            Trusted Tech
            • Aug 2010
            • 114

            #6
            Are you refering to the blue 2 wire harness?

            Comment

            • mkb
              Technician
              • Sep 2010
              • 23

              #7
              The one i have here is 3 white wire just below where the toner bottle tube. there is a senor arm and sensor there.

              Comment

              • TONERINMYNOSE
                Trusted Tech
                • Aug 2010
                • 114

                #8
                Oh yea we checked and replaced that. No dice

                Comment

                • mkb
                  Technician
                  • Sep 2010
                  • 23

                  #9
                  have you done a firmware update?

                  Comment

                  • mkb
                    Technician
                    • Sep 2010
                    • 23

                    #10
                    Could the drv pwb be bad

                    Comment

                    • TONERINMYNOSE
                      Trusted Tech
                      • Aug 2010
                      • 114

                      #11
                      i check the connector on the drive pwb no 5vdc supply from pin, in F4 i get all ones in the test mode for that sensor (also includes exhaust fan 1 and 2 lock signal, the thing that kills me is the 2 boards came out of a working machine!!! how could we have blown one?? i gues anything is possible, i have been metering/staring at this damn thing for 4 hours now, cant seem to find a solution.

                      Comment

                      • mojorolla
                        The Wolf

                        2,500+ Posts
                        • Jan 2010
                        • 2583

                        #12
                        Sounds like you have a short somewhere. I had an 8045 with a "close left door" message. Replaced the drv, same thing. Turns out the wires on the front of the fuser were pinched and grounding to the frame. Three wire sets above the front of the fuser. Also, you might want to test other sensors on that board or in that cluster. Fuser exit sensor, inverter sensor, etc...
                        Failing to plan is planning to fail!!!

                        Comment

                        Working...