Hello everyone,
I've got an 1820E that keeps on giving an E3-10 code, and when it doesn't code it prints out completely black pages with the copied image there but barely visible.
I tried the corona wire first as the most likely cause without success. Then I tried a whole different charge assembly, still no luck. Then I swapped out the whole drum/dev unit, then the Power Supply, and finally the SPC Board, but the problem persists. I have had a few instances when the thing just started working fine for a while but then eventually started coding and printing out black copies again.
Those are all the parts the service manual suggests to try. Anyone think it could be the SC Board or something else? I'm out of ideas so any advice is greatly appreciated. Thanks.
I've got an 1820E that keeps on giving an E3-10 code, and when it doesn't code it prints out completely black pages with the copied image there but barely visible.
I tried the corona wire first as the most likely cause without success. Then I tried a whole different charge assembly, still no luck. Then I swapped out the whole drum/dev unit, then the Power Supply, and finally the SPC Board, but the problem persists. I have had a few instances when the thing just started working fine for a while but then eventually started coding and printing out black copies again.
Those are all the parts the service manual suggests to try. Anyone think it could be the SC Board or something else? I'm out of ideas so any advice is greatly appreciated. Thanks.
Comment