Panasonic Workio DP-C213 Error Code E04-43

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CMS_Designer
    • Jun 2025

    #1

    [Error Code] Panasonic Workio DP-C213 Error Code E04-43

    Does anyone know what this code means? I have replaced the complete Fuser unit and even did the 120k preventive maintenance while I was at it. I originally had the E04-01 displaying which started all this, but now it's the E04-43 with the new Fuser installed.

    Any help would be grateful. I already have the Service manual for this printer but unfortunately it doesn't have any information on this error or erro in general.

    Thank you.
  • mojorolla
    The Wolf

    2,500+ Posts
    • Jan 2010
    • 2583

    #2
    Re: Panasonic Workio DP-C213 Error Code E04-43

    Go into F9 service mode under RAM Initialize, select LBP Fuser Reset. This will reset E4 codes. E4-43 refers to the rotation of the fuser roll. Are both large silver spring attached at each end? If it had a recent PM, check the fuser belt unit springs and the harness between the fuser bult unit and the press roll unit. There is also a clock sensor on the end of the fuser which can get knocked loose.
    Failing to plan is planning to fail!!!

    Comment

    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838

      #3
      Re: Panasonic Workio DP-C213 Error Code E04-43

      This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from



      Paul@justmanuals.com

      Comment

      • CMS_Designer

        #4
        Re: Panasonic Workio DP-C213 Error Code E04-43

        Thank you mojorolla!

        One of the springs did come loose. I appreciate it! Sad that something so simple gave me so much grief...

        Comment

        • mojorolla
          The Wolf

          2,500+ Posts
          • Jan 2010
          • 2583

          #5
          Glad to help.
          Failing to plan is planning to fail!!!

          Comment

          Working...